|
Post by Alan on Mar 22, 2017 10:31:37 GMT
hopefully I will be able to update and show more photos of it both being installed and in use , shortly anyway , just a teaser to get you started ok first photo a simple bracket bolted to the caliper lower bolt , this bracket holds the reciever for the pickup (speed) , you can also see one of the two mafnet bolts now retaining the disk the unit came with two small magnets , however I was not happy "glueing" them onto the disk , and chose to buy those from digical speedos lts , if this speedo fails , those are the correct bolts to use on a (very)b expensive koro or acewell type fitting www.digital-speedos.co.uk//accessories-c10/magnets-magnetic-screws-c50/koso-magnetic-disc-rotor-bolt-p405/s591still awaiting some penny washers to firmly fit the unit , the screw holes on this unit are closer together than the std sinnis thing , so I feel penny washers covered in a bit or rubber (old inner tube) will spread the load and assist with vibration UPDATE: the fuel guage flashes like a demented dirty old gentleman in a mac , however most of those speedos have a default of 95 ohms empty and 8 ohms with tank full , I connected a 47 ohm resistor (maplins = 9p) in the wire running to earth , this gives me a nice looking half tank , if you like this post , go to "home" or goto www.sinnishmc.co.uk and look at the forum , join in and contribute or read postings
|
|